How to Reset the ABS Sensor on a Camry Open the hood of your Toyota and loosen the retaining nut on the cable clamp running to the negative battery terminal using a socket wrench. Slide the cable clamp off the terminal. Wait three full seconds before sliding the clamp back over the negative battery terminal. Tighten the retaining nut using a socket wrench. Click to see full answer. Subsequently, one may also ask, how do you reset the ABS warning light? How to Reset an Anti-Lock Brake Light Disconnect the positive cable from the car battery, and then hold down on the brake pedal to drain the car’s electrical system. Change the ABS sensor if the light comes back on. Connect an OBD code reader to your car’s on-board diagnostics system to determine any other causes of the brake light. Also Know, what causes ABS light to come on and stay on? An ABS light (anti-lock braking system) that is stuck on doesn’t necessarily mean you need an ABS brake repair. The light staying on can be caused by something as simple as the emergency brake or more complicated things like a loss of brake fluid and pressure or bad hydraulic valves. Just so, how do you reset the ABS light on a 2010 Toyota Camry? How to Reset Toyota Camry ABS Light Without Tool (2004-2010): Connect terminal 4 (CG pin) and 13 (TC pin) of the OBD-II socket with a jumper wire. Turn the ignition ON but do not start the engine. You’ll see lots of flashing lights, but please just note the ABS light. To clear the codes, turn the key off. Can worn brake pads cause ABS light to come on?When the speed sensor isn’t working properly, it will cause the ABS light to come on, and your anti-lock braking system will not work properly. “Sometimes, they’re not always broken,” Manouchekian says. “They can just be cleaned off [by a mechanic].”
ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6hprBllKR6urvUZqmeq5WperW0xGaYm6tdobaotNNmpqdlkWLBsMXOrZhmm5Giv7p7